i need help
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
i need help
i took the fly wheel cover off and noticed there was a puddle of oil in the bottom, i started it up and the flywheel was wobbling a whole lot. i pryed on the flywheel and it moves up and down. did i lose my crank????
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Yeah, if that bearing is bad you got a load of work ahead of ya. You will need a flywheel puller. You can go ahead and pull that flywheel off and you should be able to see if the bearing is the problem. (I would think you could) Take the bolt off the flywheel then see if you can pull it off by hand. Do not pry it out. If it isn't loose then you have to use a puller. That will be 1 small step. Check out the manuals and have patience and be very very orderly. You don't want to loose any pieces.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
All I can suggest is download the engine manual and go to town. Pulling the motor is relatively easy. There is a walkthrough on how to do it somewhere around here. Here is pretty much what you are going to have to do.
Pull motor out
Pull flywheel
pull sidecover off
take timing chain off via crank bolt
pull head off
pull piston
pull sleeve
pull crank cartridge plate
replace bearing
put it all back together
The engine manual shows everything listed xcept pulling the motor.
Tear is up!
Pull motor out
Pull flywheel
pull sidecover off
take timing chain off via crank bolt
pull head off
pull piston
pull sleeve
pull crank cartridge plate
replace bearing
put it all back together
The engine manual shows everything listed xcept pulling the motor.
Tear is up!