Red Hot Setup For Cannondale
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
...yep, reading on-the-fly maybe not so practical....but the Sendec FSA600 tach is really a 4-function, with realtime readout plus an interesting peak-rpm recall feature, so you can monitor how high your kid revved up the motor....anyway, even more handy for setting idle and noting performance issues at certain rpms....but also handy is the total hours meter, AND the re-settable service-interval timer that you can program -- for those of us that can't remember how old that oil is!!, with a growing family of quads in the garage....This top-line Sendec is expensive but rugged, USA made $85 shipped.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE
Originally posted by Derno24
I have taken mine to the dyno 3 seperate times and the guy has never had a problem getting a tach reading out of the exsisting set-up. Not sure if this would be necessary for that at all.
I have taken mine to the dyno 3 seperate times and the guy has never had a problem getting a tach reading out of the exsisting set-up. Not sure if this would be necessary for that at all.
Very true, I get the tach reading fine on my AFR meter by tapping into the blue wire going to the coil and just make sure it's not set for inductive.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
.....just moving back to the side-benefit of the separate coil and
hotwire, we can then use any inductive products out there....the Sendec in particular is sweet, since all it uses is the single wrap-around wire downstream from the coil -- no tapping into your ignition circuit -- and still gives accurate hours along with the tach functions up to 14000 rpm. How can it work with only the 1 wire?
(maybe it has a lifetime lithium with solar recharge? or some kind of inductive recharge? who knows)...But they are widely used
on rental equipment for maintenance monitoring. I tried to make it work with our stock coils, and others here have tried similar products, but all of us have failed -- no way to get the pick-up signal.........now we can.
hotwire, we can then use any inductive products out there....the Sendec in particular is sweet, since all it uses is the single wrap-around wire downstream from the coil -- no tapping into your ignition circuit -- and still gives accurate hours along with the tach functions up to 14000 rpm. How can it work with only the 1 wire?
(maybe it has a lifetime lithium with solar recharge? or some kind of inductive recharge? who knows)...But they are widely used
on rental equipment for maintenance monitoring. I tried to make it work with our stock coils, and others here have tried similar products, but all of us have failed -- no way to get the pick-up signal.........now we can.