so the 300.00 kit shown on their website will allow me to change maps and fuel flow?
is the software user friendly or do I need to be a computer tech to run it?
Mapping & ECM
QUOTE
Originally posted by 4punksdad
so the 300.00 kit shown on their website will allow me to change maps and fuel flow?
so the 300.00 kit shown on their website will allow me to change maps and fuel flow?
It also lets you set idle, Throttle position, and monitor various things like air pressure, temp, voltage.
There is a new version they just shipped that will also let you reload the base operating code as well.
Hi I'm new to the board and thought I could be of some help. The 4 ft. serial cable that you use to connect to the dale can be exteneded buy making one your self or going to some place like radio shack and buying a serial cable. Just make sure the
sex ( ha ha he said sex) is correct on the cable ends. If you want to make one, just buy (2) D-SUB 9 pin connecters and connect only three wires to pins 2, 3 and 5. If you need futher clairification let me know.
Bill
sex ( ha ha he said sex) is correct on the cable ends. If you want to make one, just buy (2) D-SUB 9 pin connecters and connect only three wires to pins 2, 3 and 5. If you need futher clairification let me know.
Bill
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Sounds like you need to make it run richer. Before trying to adjust any fuel settings make sure the throttle min/max are set correctly.
I had same problem. First I bumped up the injector offset from 1.0 to 1.3 and it made no difference. I then changed the flowrate from 2500 to 2300 and it runs much better.
I had same problem. First I bumped up the injector offset from 1.0 to 1.3 and it made no difference. I then changed the flowrate from 2500 to 2300 and it runs much better.