how to mount the Denton steering stabilizer
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
how to mount the Denton steering stabilizer
Does anyone have a pic on how to mount the Denton steering stabilizer? I just called them to see what they have and the only thing that they don't have anymore is the stem mount, which they said I could just use the hole by the ball joints. So far I have been told to go with non-rebuildable works better ( I have only been told this) Now I have also been told that I could get the Honda 450R and mill out the mount, but I am not sure how much you would have mill out.
So does anyone have pic's on the install/mount and does anyone suggest just going with the Honda 450R one??
Also can anyone do better than the 135$$
Can everyone tell that I am a newbie yet, questions question questions!!!
So does anyone have pic's on the install/mount and does anyone suggest just going with the Honda 450R one??
Also can anyone do better than the 135$$
Can everyone tell that I am a newbie yet, questions question questions!!!
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Ok so I got my Denton steering dam in today, so what does the 7 position adjustability mean?? Is there a way to adjust how much it will absorb?? also I didn't request the 400ex bracket for the steering stem, I was going to mount as shown in the following thread
http://www.cannondaleriders.com/vbb/showth...ighlight=denton
will this mounting method still work just the same??
http://www.cannondaleriders.com/vbb/showth...ighlight=denton
will this mounting method still work just the same??
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm