Won't start!
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Won't start!
I've owned my 02 Cannible for about a year and a half now and has ran great. Was riding her pretty hard last week and after about an hour it started running kinda rough. We stopped and took a little break and it didn't start as easily as it has before and when it did it cutting out while idleing. I parked her and quit for the day. Went to ride yesterday and it wouldn't start at all. I changed the plug, filled her up with fresh fuel and she fired up but wasn't running smooth. I let her run for about 5 minutes and went for a little spin. Ran rough for about 10 minutes then died and won't start. Need some ideas on where to start at.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
But how much power is the battery putting out? Don't assume that beacuse it's new it is working correctly. It's too simple to check to rule it out.
Also check and make sure your idle screw has not backed out. I like to rule out the simple things.
Jaybr is right about the filter. Sometimes they last a long time. But all it takes is a small peice of something to ruin a good one. For $.85 it's worht ruling out.
Also check and make sure your idle screw has not backed out. I like to rule out the simple things.
Jaybr is right about the filter. Sometimes they last a long time. But all it takes is a small peice of something to ruin a good one. For $.85 it's worht ruling out.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
my 01 cannibal did the same thing, and the flywheel had gotten loose and started to waller out the flywheel on the crank. is was still close enough that the crank position sensor could still get a reading, but far enough out to screw up the timing. just something to check, its only 4 screws to get the cover off:)