While You were ALL at the group ride...
The only problem with smacking the spindle with a hammer, is it is aluminum and will dent up easily. I loosen the ball joint nut, just to then end of the threads, use a small propane torch to heat the spindle around the ball joint, then smack the nut with a hammer while pulling. It pops right out, and your spindle still looks new.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Heres the deal i do not need to sa ve my ball joints they can be destroyed the new a arms are heim joints i just need to get the spindle seperated as far as i know the threaded part is connected to the ball joint so i do not need to save this correct or does the threaded part stay on the spindle.....I have found about 5 more cracks in the swingarm now that i have pulled it off
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE
Originally posted by wanablaze
A little tip Maz taught me at Socaldale: Grab a hammer and give the spindle (around the balljoint) a good whack while pulling on the a-arms. May take a few whacks, but should pop right out and you can have the job done in a couple minutes.
A little tip Maz taught me at Socaldale: Grab a hammer and give the spindle (around the balljoint) a good whack while pulling on the a-arms. May take a few whacks, but should pop right out and you can have the job done in a couple minutes.
This works well but I allways put another hammer on the opisite side you are hitting you don't have to hit it as many times or as hard. Also if you have someone to help have them put a little pressure between the knuckle and the a-arm with a prybar
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
If I had the time and tools required, I'd do it Doug's way. Instead I hurry up and whack it with a hammer while pulling. It does dent it a little. No assitance needed, though.
On a side note: Marc, you're right, Josh did show us that, and as Maz was leaving he showed Thomez for a second time.
:hammer: :hammer: :hammer:
On a side note: Marc, you're right, Josh did show us that, and as Maz was leaving he showed Thomez for a second time.
:hammer: :hammer: :hammer:
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I take two bolts using one with a nut on it and the balljoint nut still on I put the bolt in between the two studs and turn the nut from ball joint against the nut on the bolt then when tight as possible just tap spindle at joint remove the bottom one first.Repeat using the other bolt which is longer.