the taper is the same as the 'honda', but you still have to use the brass 'sleeve' to compensate for the larger diameter of the cannondale spindle holes.
i dont remember the part #, ill try to swing by the store the next time i make it to town:)
what color?
http://forums.cannondaler.com/viewtopic.ph...t=4119&start=15
this could help some
this could help some
I like the one with the sealed auto ball joint and a nut on each side of where it goes through the arm. It would need a spacer to center it. Simple and no need to weld or remove the arm. It looks like someone else did it already. A mazda 323 joint ? I cant believe we all missed that post. It was a month after the first ball joint post on cannondaler.
The only one I saw using a gm part was bphilmans. Ill bet that setup is rated for 20 times what the quad could ever dish out. It will last forever.
The only one I saw using a gm part was bphilmans. Ill bet that setup is rated for 20 times what the quad could ever dish out. It will last forever.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Hey Wistech little late but here is link to the post your talking of Mazda 323 joints.
http://forums.cannondaler.com/viewtopic.ph...t=4119&start=15
http://forums.cannondaler.com/viewtopic.ph...t=4119&start=15