once you pull the boot over, then make a small slit for the zerk to poke through. Then fill her up with grease!
You don't even have to mess up your toe settings to install them, just unbolt the joint from the spindel and stem, pull the bolt out of the ball, slide the boot over, reinstall the bolt into the ball, then pull the boot back over the whole thing.
Jeff, I got your tie rod end boots today!
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm