quad is creeping

Message

raptor0443 · #1 Post by **raptor0443** » Thu Mar 10, 2005 11:30 pm

i just adjusted my brand new clutch on my quad, and know all the plates are in there right, but when i go to start the quad or give it gas with the clutch pulled in the quad creeps forward a little bit, and it is causing it to be a little harder to to start because the clutch isn't fully disengageing, i turned the set screw all the way in and then back out 3 turns should it turn it back in a little? please help!!!!!!!!!!

theJeStEr1340 · #2 Post by **theJeStEr1340** » Fri Mar 11, 2005 12:54 am

Is it a hydro or cable clutch?

raptor0443 · #3 Post by **raptor0443** » Fri Mar 11, 2005 1:11 am

hydro

quadman22 · #4 Post by **quadman22** » Tue Mar 15, 2005 3:32 am

u may have to tweak that adjustment screw until u find where it should be. Also make sure the plates are well oiled... u may have to let the motor run a bit to get this to happen because the plates sometimes stick together. i had this problem. it all works good now. but just mess with the screw until you find where it works the best.

azcannon · #5 Post by **azcannon** » Tue Mar 15, 2005 4:08 am

When you got the new clutch were the plates dry or were they oil soaked ? I read in the manual that they should be soaked overnight before installation

Canniboomer · #6 Post by **Canniboomer** » Tue Mar 15, 2005 4:29 am

For sure, and if not soaking overnight, just rub the frictions good with tranny oil first -- oozy gooey is good

Cannondaleriders

quad is creeping

quad is creeping

was the new clutch wet or dry?