Well my guy actually got around to testing his program.Works fairly well but islands are a bit off for my taste pin isnt held as firm as stock so he is doing some tweaking of program.Here was first try with steel.
Oops, forgot to go over there today. Well, I should be able to pick these up on Monday. Dang got too busy to remember to check in on these. Looks good steve.
Yup. They are going to test fit the pieces to be sure they fit properly. I think I know why they said 3 weeks to get to them. They had to find a whole day for one of the good machines to do these. And that sucks up profits big time on these little parts. I will post on Monday pics or status. I think Jeff was planning on running these on this last Thursday or Friday.
Yes if its right at both closed and open the pin that opens valve will be in correct position and not be able to be turned much at all.Pain in butt to get right.
Look what I got!These 5 were contracted to be made about 6 months ago.Still waiting on Happys.But after multiple trys I am satisfied with these 5 and very happy with the fit of pivot pin.Let the testing begin.Wistech gets one me another and that leaves 3 more.Cost me $250 for all five because of development time.Anyone else want to be a tester?$50 installed in your cam.