Parts FAQ
flywheel puller
i just called steahlyoffroad.com at 1-800-800-2363 the puller stock no. is "E-12". price was $15.00 + shipping.
:head:
:head:
heres some stuff i found out.
front hubs-400EX
front rotors-400EX
front brake calipers-DS650
rear axle bearings-250R
front spindles-400EX (must use stock inside spacer from honda)
if you run LSR arm on the front, DONT buy replacment parts from them. heres a little info i found surprising.
Upeer A-arm rod end LSR retail 23 bux!
Summit racing retail 5.95!!
1/2 inch right hand thread (male)
tie rod ends LSR retail 26 bux!
Summmit racing retail 7.95!
1/2 inch right hand, left hand thread (female)
ball joints LSR retail 26 bux!
Parts store 14.95
GM truck tie rod end!! he he he
i build drag cars, and figure if these rods ends are good enough for the 4 link on cars, they'll do JUST FINE on a 400 pound quad!!
hope this helps a few out!
front hubs-400EX
front rotors-400EX
front brake calipers-DS650
rear axle bearings-250R
front spindles-400EX (must use stock inside spacer from honda)
if you run LSR arm on the front, DONT buy replacment parts from them. heres a little info i found surprising.
Upeer A-arm rod end LSR retail 23 bux!
Summit racing retail 5.95!!
1/2 inch right hand thread (male)
tie rod ends LSR retail 26 bux!
Summmit racing retail 7.95!
1/2 inch right hand, left hand thread (female)
ball joints LSR retail 26 bux!
Parts store 14.95
GM truck tie rod end!! he he he
i build drag cars, and figure if these rods ends are good enough for the 4 link on cars, they'll do JUST FINE on a 400 pound quad!!
hope this helps a few out!
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm