rpm axle help

Message

guthrie08 · #1 Post by **guthrie08** » Sun Apr 10, 2005 12:06 am

i got my rpm axle set in the swingarm, i have the brake hub in and cant figure out how to tighten it up with the lock nut. I screw the lock nut the whole way on the threaded sleeve and it does not stay tight against the brake hub. does anyone with an rpm axle or aftermarket have any tips on how to get the lock nut on tight. thanks

cannondale27 · #2 Post by **cannondale27** » Sun Apr 10, 2005 12:22 am

Do you have the clip or clips in the axle groove.Doesnt RPM use their own Locknut?

Derno24 · #3 Post by **Derno24** » Sun Apr 10, 2005 1:01 am

PICS PLEASE!

guthrie08 · #4 Post by **guthrie08** » Sun Apr 10, 2005 5:44 am

ill try to get some pics up soon, i have the clip in the groove on the axle and i have rpms locknut, im using the stock threaded sleeve and it wont tighten against the brake hub.

cdrookie · #5 Post by **cdrookie** » Sun Apr 10, 2005 10:46 am

i'm just guessing here...maybe put a washer in between the hub and collar? or a couple washers since the factory ones are pretty thin.

haydug · #6 Post by **haydug** » Sun Apr 10, 2005 11:49 am

RPM uses their own lock nut, stock will not work. :cry:

guthrie08 · #7 Post by **guthrie08** » Sun Apr 10, 2005 4:33 pm

i have rpms locknut and it still wont tighten up, ill post again after trying some washers and ill get some pics up. thanks

guthrie08 · #8 Post by **guthrie08** » Sun Apr 10, 2005 9:51 pm

to start off heres a pic of my polished swingarm. all i used was wizards polish and a rag and it turned out great.

guthrie08 · #9 Post by **guthrie08** » Sun Apr 10, 2005 9:55 pm

heres a pic of my houser +3 and elka quadrates which i cant wait to ride.

guthrie08 · #10 Post by **guthrie08** » Sun Apr 10, 2005 9:57 pm

heres a pic of the axle with the snap ring in and the threaded sleeve.