Blaze A-arms

Message

DMAC10 · #1 Post by **DMAC10** » Fri Apr 15, 2005 2:56 pm

Quick question.

Are the Blaze a-arms +1 in width or are they stock width. If they are +1 ,do I need different tie rods instead of stock cannibal tie rods.

jacobw · #2 Post by **jacobw** » Fri Apr 15, 2005 3:05 pm

blaze arms are stock width arms just like on the cannibal, speed,glamis. You dont need any special shocks or tie rods.

DMAC10 · #3 Post by **DMAC10** » Fri Apr 15, 2005 3:08 pm

Thanks
I was hopeing that they were + 1, oh well its was worth a shot.

jacobw · #4 Post by **jacobw** » Fri Apr 15, 2005 3:13 pm

you could make them plus one buy using ars-fx balljoints or someother. Happyboy made his stock arms plus one. I will dig up the link for you. Here is the link:

http://www.cannondaleriders.com/vbb/showth...highlight=aarms