Looking for feed back
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (kenny mariscott @ Feb 16 2007, 12:43 PM) <{POST_SNAPBACK}>
I hadn't even thought about the flywheel, I was having a clutch basket made. I'm not sure where to start on a flywheel. Only because I never taken one apart. How about a billet replica of one just machined to look like a flywheel? lol...
I have one cut open,and one spun after being pinned. I'll send them to you if you think you can do something?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Something I keep thinking about, Is to make a little resivor(sp?) to mount at the rear of the engine were the oil line is located. My thoughts were to run the oil line from the frame to the lower portion of the resivor. I was thinking of a drain plug with a removeable screen and magnet. then going from the top of the resivor to the oil inlet on the back of the engine.