shorty success
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
shorty success
i made my ti moto exhaust into a shorty. worke out perfect, the job looks factory. used the hydroulic horizontal band saw, smoothed the cut end of the pipe with the disk sander, drilled new holes and put new pop rivets. very proud of my work. the only thing that went wrong was when i was cutting the blade got stuck on some packing and the exhaust started to spin in the vice (dont worry it was flat no teeth) and there are some line on the exhaust, but there not serious at all.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
ok heres my problem.i knew the core of my fmf ti4 was broken.u could here it.so i open up the can from the header side of course and there is no packing:( i packed it at steves house june 25th weekend.so me and my boss cut the broken edges off the core and weld it back on.the only problem is i want to shorty it now that its apart but dont know how to go about it. i was thinking just cut down the core that the packign goes around towards the end cap of muffler and the cut off the can on the end closer to the header.drill new wholes and good to go.what do u think?
kyle
kyle