Nitro-propane
Nitro-propane
Has anyone here ever tried a nitro-propane additive in the Cannondale? If so what were the results and what did you end up setting you injector off-set and flowrate at to make it work?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Nitro-propane is a liquid additive to the fuel that uses Nitro with propanol. It mixes with gas whereas nitromethane does not. It does not actually burn. It breaks down at above 500 degrees F in the cylinder and releases extra oxygen. It raises the specific gravity of fuel from around .75 to around .95. You have to run your settings extra rich to compensate for the extra oxygen. When mixed correctly, it is good for a 10-15% HP boost. The dangers are extra heat and detonation if the mixture is too lean.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Jwheat was spot on.
Another additive that I find much easier to deal with is propylene oxide. I mix it all the time and at times up to 20%.
It ads extra oxygen directly to your fuel. I never used it in a injected quad though. On bikes I usually run one main jet higher.
It really helps with low to mid range power. I have made close over 4 hp on a 450f with propylene oxide, toluene mix.
We have been running it for years and have never lost a motor that we can attribute to a fuel were mixing.
Another additive that I find much easier to deal with is propylene oxide. I mix it all the time and at times up to 20%.
It ads extra oxygen directly to your fuel. I never used it in a injected quad though. On bikes I usually run one main jet higher.
It really helps with low to mid range power. I have made close over 4 hp on a 450f with propylene oxide, toluene mix.
We have been running it for years and have never lost a motor that we can attribute to a fuel were mixing.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm