I have a 2003 cannibal with a blaze map in it. when i press on the gas in first gear the first couple of seconds it kinda like jolts back and forth kinda like it wants to stall but when it hits a higher rpm its fine. also its good in the rest of the gears. i hooked it up to the d&M kit and it reads
TPS sensor closed .34
" " open 4.18
Throttlebody leakage 0.5
fuel inj flow rate 2300
injector offset .70
numerical cal id 32300
Should the throttle body leakage be at 0? like it was stock map?
I dont know what is causing this but would love to have it fixed. thanks.
quad help
the stock setters are
tps sensor closed .31
" " open 4.34
throttlebody leakage 0.0
fuel inj flow rate 2603
injector offset 0.88
numerical cal id 32300
i didnt mess with anything. it ran good while i first bought it but i did have to change the spark plug because i flooded it so i dont know if that had to do anything with it. thanks for helping me out.
tps sensor closed .31
" " open 4.34
throttlebody leakage 0.0
fuel inj flow rate 2603
injector offset 0.88
numerical cal id 32300
i didnt mess with anything. it ran good while i first bought it but i did have to change the spark plug because i flooded it so i dont know if that had to do anything with it. thanks for helping me out.