With out measuring my stock width I went ahead and bought a +4 Durablue axle and with all the spacers I am only at 46 1/4" with 8x8.5 with 4+4.5 offset. I was just assuming a +4 would get me around 50". So are there any axles that are as wide as the "Moto" axle? RPM or LSR? Thanks
I am correct in assuming that +4 means +2 per side? The axle is 4" longer than the stocker. Thanks
Axle widths?
Yes, plus 4 means 2 per side for 4 total...Your problem is your wheel off-set. Stock cannondale offset on the rear is 4x6, so you are narrower by 1.5 inches per side, 3 inch total. If you had that back, you'd be 49 1/4 inches wide, just where you want to be. I have the +4 lonestar and just measured it tonight. It is 48.5 inches wide. I run ITP 9inch beadlocks, not sure of the offset, it is hard to measure exact, but I think it is 3x5 or 3.5x5.5, something like that. On beadlocks, where are you supposed to take the outer measurement from anyway? The outside of the beadlock ring? I'm not sure if mine are 9x9 or 9x8.